What are dirt bike graphics printed on?

What are dirt bike graphics printed on?

CONVEX® Vinyl for MX Decals & Graphics CONVEX vinyl media for MX decals gives you everything you need for printing decals and stickers for dirt bike plastics and other hard-to-stick-to surfaces.

What material are dirt bike graphics?

Typically, dirt bike graphics are made by printed on vinyl with an adhesive backing, then are laminated to protect the colors from wear. Depending on the thickness and grade of materials used, some suppliers’ products vary in difficulty of application.

How thick are MX graphics?

The graphics are quality 19 mil thick. But it is important to learn what that means to see if other companies are telling the truth. All graphics are printed on a sticker vinyl.

How thick are dirtbike graphics?

If you work your bike to the max, you’ll want your dirt bike decals to be between 16-20 mils thick (or around 400-500 microns). Lower quality and cheaper vinyl is available, but might not last as long. It all depends on how hard you ride and the conditions you ride in.

Can you wrap a dirt bike?

Basically, you can wrap any brand or style of motocross or dirt bike, so long as you only wrap the hard, non-porous parts, such as the fenders and skid plates. Some of the most common types of Dirt Bikes that people like to wrap include: Yamaha.

Can you put new graphics on old plastics?

“First, when installing graphics on old plastic you want to remove the old decal and then you need to clean the plastic really well,” advises Hayes. We use Motorex brake cleaner.””New plastic is the toughest. You almost want the plastic to look dull after you’ve cleaned it. Alcohol will not work; soap will not work.

Why are dirt bike graphics so expensive?

Good graphics are not cheap. The plastic sheeting, the machines required to cut them, the failure rate when printed and cut, all contribute to the cost.

How long do MX graphics last?

We’ve had national level MX riders put 100 hours on their graphics and they still look great. On the flipside, we’ve seen some parts of certain bikes wear faster than others, even at local amateur levels.

How do you get air bubbles out of motocross graphics?

You need to relieve the trapped air. Use a pin or razor and make a tiny hole where the bubble is. Apply a little heat and rub your thumb or graphics tool/rubber straight edge over the bubble.

How much does it cost to get a dirt bike wrapped?

To wrap a motorcycle will cost approximately $1,500 to $4,000. Depending on the quality of material and how many parts you want to be wrapped.

How hard is it to wrap a bike?

Most motorcycle graphics are not that complicated, so you shouldn’t have too much trouble applying vinyl wrap by yourself. I tend to stick with 3M’s 1080 series of vinyl wrap. The largest project I ever did with it was a car roof, and it was surprisingly easy to work with at that scale.

What to use to clean plastics before graphics?

First, use brake cleaner and paper towel to clean plastics matte. Then use an alcohol-based window cleaner and wipe all plastics very dry.